Common problems and solutions for cans filling machine
Most of the cans filling machines are widely used in food, medicine, daily chemicals and other industries. Due to the variety of products, when production failures occur, it will not have an underestimated impact on production.
Most of the cans filling machines are widely used in food, medicine, daily chemicals and other industries. Due to the variety of products, when production failures occur, it will not have an underestimated impact on production. Today, Xiaobian will introduce you to the common problems and solutions for cans filling machines.
Question 1: The filling capacity of the can filling machine is not allowed or not discharged.
1. Is there any foreign matter in the quick-installing three-way control valve? If so, please arrange it; if there is air in the leather tube of the three-way control valve and the filling head, if there is air, try to cut the air.
2. Check all the seals for damage. If it is damaged, please replace it with new ones.
3. Whether the filling valve plug has a stuck appearance or delayed opening. If there is a jam, the core should be installed from the head. If the opening is delayed, the thin cylinder throttle valve should be adjusted.
4. Whether the filling speed is too fast. If it is too fast, adjust the filling speed throttle valve and lower the filling speed.
5, all the clamps, leather tube buckle can be sealed, if not sealed, please correct.
6. Is the magnetic switch loose? Remember to lock it after each adjustment.
Question 2: The material of the can filling machine is at the rear end of the material tank
1. Whether the material cylinder is in the center of the material cylinder bracket. If there is any change, please install the position from the head.
2. Whether the piston and piston rod of the material cylinder are tight, if it is loose, please lock it.
3. Whether the O-ring seal of the cylinder piston is damaged, if it is damaged, please replace it.
Knowledge Zone: Comparison of atmospheric pressure can filling machine and pressure filling can filling machine
1. Working principle: The atmospheric pressure can filling machine relies on the gravity of the material to flow from top to bottom to the filling head; the filling and filling can filling machine uses the piston to feed the material cylinder, and then uses the piston to inject the filling head. For filling, the injection canning machine is also called a piston can filling machine.
2. Applicable materials: According to the principle of atmospheric pressure can filling machine, it is suitable for water agent with better fluidity; and the filling and filling can filling machine is suitable for high viscosity liquid and paste, so it is injected. Cans filling machines are also known as high viscosity cans filling machines.
3. Price: The structure of the atmospheric pressure can filling machine is simple and the price is low; the structure of the pressure-filling can filling machine is complicated and the price is high.
Nicotinamide Series
Insen Biotech supply NMN, NR, NAD with over 99% purity, and now our products can keep stable quality for 2 years even at room temperature after process improvement. What' s more, customers usually buy other products as combination to make capsules together, such as resveratrol, Nicotinamide, etc., caz the combination has better effect. Please feel free to contact Insen if you need any of them.
Nicotinamide Series,Nicotinamide Riboside Nr,Nicotinamide Riboside Chloride,β-Nicotinamide Mononucleotide
Hunan Insen Biotech Co., Ltd , https://www.insenhealth.com