Mobile high shear emulsifier use method
Red Pepper,Red Pepper Dry Pepper,Especially Fresh Flavor Red Pepper,Fresh Flavor Red Pepper Sichuan Liuhang Agriculture Co.Ltd , https://www.lhagriculture.com
The mobile high-shear emulsifier is driven by the electric motor. The high-speed rotating rotor sucks the material from the bottom of the container into the rotor area and withstands a strong mixing effect. After the material is forced to pass through the precisely matched stator-to-rotor clearance, it is smashed from the stator hole. Out. Subject to severe mechanical and hydraulic shearing, the particles are torn and comminuted, while new materials are drawn into the center of the rotor, and the pushed material changes direction on the wall of the container, completing a cycle.
The unit can be fixed in either a container or on a movable hydraulic lifting frame. Used in a variety of containers, the bottom bushing is used to maintain stable operation of the high speed rotor drive shaft. The bottom support portion is securely fastened to the underside of the motor by four support rods. The drive shaft and the rotor are connected to the shaft of the motor through a strong coupling, which is extremely convenient for assembly and disassembly. If necessary, thorough cleaning and disinfection can be done during the batch of material handling. The unit can be safely disassembled and assembled in a matter of minutes. The processing capacity is 15 liters to 2000 liters and the power is 1.1 kW to 75 kW.
Instructions
1. Loosen the refueling screw of the manual hydraulic cylinder during work and tighten the opening screw.
2. Press the handle to adjust the power head to the required working position. Generally, the diameter of the power head should be 2-3 times higher than the bottom of the container.
3. Select the standard stator head according to the material and operation requirements of the fluid to be processed, and at the same time adjust the working position of the blade with the downward thrust on the rotating shaft.
4. After the stirring is finished, press the handle again to make the power head in the * high position, which is convenient for taking out the liquid storage container. To lower the power head, loosen the switch screw.
Recommended procedure for feeding:
When using a hybrid emulsifier, the recommended material supply process is as follows:
1. Add all components with a small viscosity to the container and start mixing.
2. Add the remaining liquid or capacitive components.
3. Add a solid that requires vigorous mechanical agitation or a solid that requires a certain amount of time to carry out a chemical reaction.
4. Add the remaining solids, including solids used to establish viscosity or stabilize the formulation.