Tractor care system care
Flex Clear Tape,Clear Flex Tape,Flex Seal Clear Tape,Clear Flex Seal Tape Kunshan Jieyudeng Intelligent Technology Co., Ltd. , https://www.jerrytapes.com
1 Correct operation, drive with care. In use, care should be taken not to cross the obstacles at high speeds, not to make sharp turns under heavy loads, to drive at low speeds on low-lying roads, to avoid emergency braking, and not to make the walking system serious when climbing on load or on muddy roads. Slippery. 2 Check and adjust the front wheel alignment. If the front wheel of the tractor is excessively inclined and the front beam is too small, it may cause partial wear. The front axle bearing and the shaft sleeve are deformed by the impact, or the front shaft expansion sleeve is fastened by the fastening device, which will cause the front wheel alignment angle to change, causing abnormal wear. Therefore, always check the front wheel's positioning angle during use and adjust the front beam. 3 Pay attention to the operating conditions. Avoid trapping when working in low-lying paddy fields. After a car has been trapped, it must be removed by traction and implemented. Excessive throttle is not allowed to make the traveling system idle at high speed. When working in drylands where the roots are strong or stay high, the tires are prevented from being rolled or the shaft is entangled with the crop stalks. 4 Maintain normal tire pressure and track tension. Before the operation, we must carefully check whether the tire pressure is normal, the transport operation can be slightly higher, the field operations should be lower; the winter can be slightly higher, and the summer season should be lower. Tracks that are too loose and too tight tend to cause accelerated wear on track shoes, track shafts, and wheels. Therefore, proper tension must be maintained. 5 Timely cleaning and cleaning. Do not contaminate tires with corrosive substances such as oils, acids, and alkalis. Tracks and wheels stained with sludge should be cleaned in time to keep the walking system clean. The end of the roller bearing oil seal device should be timely cleaning, inspection and maintenance.