Ten key points for installation, use and maintenance of air purifiers
1. The installation location of the air purifier equipment should be far away from the high-speed source and source. It should be installed in various purification plants or air-conditioning plants. It can be installed horizontally or vertically according to the needs. When installing, place 5MM thick latex sponge on the installation surface. The gasket frame ensures air tightness. 2. The installation hole size of the air purifier self-cleaning device is determined according to the size of the self-cleaning device. 3. If the air purifier equipment uses a voltage regulator, the voltage of the regulator can be adjusted without changing the average wind speed of the wind surface, so that zui economically uses the self-cleaning device to improve the service life of the high-efficiency filter. 4. In order to ensure the cleanliness of the purification area, it should be turned on 15 minutes before each use. 5. The clean air blowing surface should be facing the working area that needs to be cleaned, and large areas should be avoided during the period. In the purification area, the action of obviously disturbing the laminar flow should be avoided as much as possible. 6. According to the cleanliness of the environment, the non-woven filter material in the top pre-filter is periodically removed for cleaning. The interval is generally 3-6 months. Generally, when the non-woven filter material in the pre-filter is black. , can be removed for cleaning, or replaced. 7. Regularly (usually twice a month) use the Y9-4 dust particle counter to measure the cleanliness of the room or work area where the equipment is installed. If the technical parameters are not met, the high-efficiency filter should be replaced. The service life is 9600 hours 8. When replacing the high-efficiency filter, the pressure box on the front of the purifier must be removed, and the high-efficiency filter should be taken out. When replacing the new high-efficiency filter, the arrow on the high-efficiency filter should be directed to the gas flow direction. 9. After replacing the high-efficiency filter, use the Y09-4 dust particle counter to scan the leak, paying special attention to whether the surrounding frame is good. 10. Electrical faults require professional maintenance. Air purifier equipment should not be used at temperatures greater than 50 ° C and open flames are strictly prohibited. Light Color Quarters Walnuts Kernels 1/4 Walnut Kernels , light color, broken while hand shelling .size is equal to or bigger than 1/4 walnut kernels, Light Color Quarters Walnuts Kernels,Light Color Walnuts Kernels,Hot Walnut Kernels Light,Walnut Kernels Light Quarters Weishan Yuanxing Walnuts Co.,Ltd. , https://www.walnutsxxy.com