Stripping and processing of foxeskin
First, peeling time from late November to late January the following year for the fox fur mature period. The mature fur is bright, fine and dense, and the tail hair is fluffy. When the fox body is twisted, the whole body has obvious "cracks". This is the best time to take skin. Second, skinning method will be poisonous after the death of the fox began to peel. The order of skinning is: first use scissors to cut the skin from the foot part of the hind limbs of a fox, pick the skin along the inside of the long hairs at the inside of the stock to the front of the anus, cross the anus and pick it up to the foot of another hind limb, and then from below the anus along the midline of the abdomen Pick to the tail, remove the hairless area around the anus, and then use your fingers to insert the skin between the anus, separate the flesh with the strength of the fingers, and then hang the two hind legs of the fox on the fixed hooks and turn the skin downwards to make a tube. Peel and peel the urethra and cut the urethra with scissors. Forelimb stripping method is the same as the hind limb, but the knife edge cannot be opened too long. When peeling the head, keep ears, eyes, nose, and lips intact on the skin. Third, the processing method with a diameter of 20 cm, the tip slightly sharp smooth sticks and other hard things in the skin, and then use a scraper to scrape the oil from the tail to the head, while scraping edges with sawdust suede plate and Fingers to prevent oil from soiling. When the oil is used, the force should be uniform. After the oil is scraped, it should be washed repeatedly with a soft sawdust. Last year, the oil and dirt on the skin plate and hair are washed until fluffy and clean, showing the inherent color and luster. With the leather fur facing inwards, spread it with a suitable mallet and place it on a wooden board. Fix the head so that the forelegs will naturally hang down and straighten. Pull both ears together to stretch the head, and then pull the arm. Stretch as far as possible, and the hind legs lie flat on the wooden board, then pull the backboard and tail, and fix it with a push pin, and put it in a ventilated place to dry. Avoid high-temperature baking. When the skin is 6 to 7 dry, the skin plate is removed and turned over so that the hair is outward, and then the wood is dried. After drying to 90,000 kilograms, remove the raft and hung it in the room for further drying. Place it in a wooden box or carton and put some camphor in the box and sell it as soon as possible. Pet Massager,Cat Massage,Dog Massage,Pet Groomer Tools Shenzhen Jie Zhong Lian Investment Co., Ltd. , https://www.szmeizons.com