Agricultural machinery winter maintenance tips

After entering the winter, many agricultural tools are idle, especially in rain and snow, the temperature is low, and agricultural implements are prone to aging and damage. In order to prolong the service life of agricultural implements, it is very important to maintain and store agricultural implements. Please pay attention to the following matters:

First, after the use of agricultural machinery in winter to a full maintenance in a timely manner.

Second, iron parts should be cleaned, painted with oil, butter or antirust paint after drying, especially the screws and Other connections, to prevent rust to shorten the service life.

Third, the rubber parts of the equipment are damp or stained with oil, and they tend to age and crack. This shortens the service life. Therefore, the V-belt or flat tape on the machine tool should be removed, hung on the wall or placed in a dry and ventilated place. During parking of the tractor during storage, jacks or bricks are used to jack up the front and rear axles of the locomotive to lift the tires off the ground, not to bear the load, and to maintain proper air pressure.

Fourth, to prevent deformation of spring parts, clutches of hand-held tractors are often combined type, after the storage parked, the handle should be placed in the "closed" position, otherwise, the clutch spring long-term compression, will lose flexibility caused by deformation, scrapped in advance; The intake and exhaust valves of the engine should also be placed in a closed state to avoid long-term pressure on the valve spring and to prevent dust from entering the cylinder.

Fifth, to prevent the motor from getting wet, the motor used in farm machinery is not used for a long time and it should be placed in a dry, ventilated and clean warehouse. To prevent the internal insulation performance of damp street surface from falling, causing short circuit, grounding, leakage, and even burn out the coil.

Sixth, when the tractor is not in use in winter, due to long parking time, the battery should be removed, the surface cleaned, the surface of the electric pile painted "Vaseline" and then placed in a dry warmer room, once a month to make a supplementary charge, In order to prevent the battery from curing.

Fingerrint Time Attendacne

Biometric Attendance System,Fingerprint Attendance Machine,Fingerprint Time Attendance Machine,Biometric Fingerprint Attendance System

GRANDING TECHNOLOGY CO LTD , https://www.grandingsecurity.com