Pigeon Breeding Shed Design Project
A pigeon breeding colony group breeding loft The group lofts are mainly suitable for young birds. In general, single-family cottages can be used to renovate existing homes. Since grasses are prone to damp and mildew, it is easy for pigeons to be affected by fungal attack, so do not use grass tails as lofts. It is advisable to use a brick or wooden structure for the new loft. Single row cottages, each 5-5.2 meters wide and 12-18 meters long. It is 2.5 meters high and it is divided into 4-6 small rooms with nets or bamboo. Each room can raise 50 pairs of pigeons. The front and rear windows of each loft should be opened on the front and rear windows. The front window can be lower than the ground. The window room area is 1.2-1.4 square meters, and the front window is 1-1.2 meters off the ground to facilitate the climate wind in summer to enter the building. The rear window is generally 1.6-1.8 meters away from the ground to avoid the invasion of the north wind in winter. At the same time, about 20 centimeters from the ground under the back wall, several open and close windows (40 centimeters and 60 centimeters or 40 centimeters and 40 centimeters in size) should be opened to allow ventilation and ventilation in summer and humid weather. It is better to use large red bricks or triads on the floor. The floor is required to be smooth and clean, and it should not be exposed to water in wet weather. The ground is 30-40 cm higher than the ground of the sports ground, which can keep the habitat dry. In addition, on the sunny side of each loft, there must be a sports ground. Its length and width are similar to those of the lofts, and its surrounding height is 2.5 to 2.8 meters. It can be surrounded by steel, round logs or cement columns and galvanized lead wire. Nylon mesh cover. For ease of operation and management, the gate position of the stadium should be the same as that of the loft. Second, the pigeon breeding cage shed breeding loft The so-called cage breeding is to properly pair the production breeding pigeons one by one to one pair, so that they can share, eat and drink. Its advantage is that the loft has a simple structure, low cost, easy management, stable pigeons, and a high utilization rate of lofts. There are two types of this loft. 1. Double row loft The truss often uses a herringbone type, which is 2.5 meters high in the north and about 2.8 meters high in the south; if the flat roof is covered with fiberglass tiles or asbestos, it should be reinforced and plugged to prevent tornadoes, typhoons and storms. The depth of the loft is 2.2 meters. There is a 0.8 to 0.9 meter wide operation lane in the center and a drainage ditch around. The pigeon cages are opposed to each other. There may be three or four-layer cages. It is better to use tarpaulins to hang the cages from the top to the ground. In winter, the tarpaulin can be kept warm, and in the other seasons, the tarpaulin can be rolled up for ventilation and light transmission. The outer and upper layers of the cage are barbed wire. There is a wooden door or bamboo on the side of the operating channel. The trough and health sand cup are hung on the cage door for feeding and observation. To facilitate water supply and flushing, a long sink is installed on the outside of the cage. The width of the cage is 60 cm, depth is 60 cm, height is 55 cm, there is no space between the cages of the upper, middle and lower floors. The bottom of the bottom floor is about 20-50 cm from the ground. The length of each row of cages is typically 18-21 meters for a 3-layer cage. 2. Single row loft The structure of the single row and double row loft is basically similar. In the single row loft, only the side of the sun is placed on the side of the sun, brick walls are used on the facade, and several windows are open on the wall. This is different from the double row. The advantage of the single-row loft is that it faces the south, so it is sunny, well ventilated, and warm in winter. However, its disadvantage is that the breeding area per unit area is reduced by half compared with the double row and the area is larger. Manual Massage Collapsible Foot Spa Massager The Manual Massage Foldable Foot Spa Massager is a portable compact device designed to give your feet a relaxing massage experience. Its foldable design makes it easy to store and transport, making it ideal for the frequent traveler. Manual Massage Collapsible Foot Spa Massager,Foot Bath Massager Machine,Electric Heated Foot Spa,Foot Bath Tub Huaian Mimir Electric Appliance Co., LTD , https://www.mimirfootbath.com
Massagers typically have multiple massage rollers that apply pressure to different areas of the foot, providing a deep-tissue massage that can help relieve tension and improve circulation. Some models also feature heating and vibration to further enhance the massage experience.
To use the massager, you simply fill it with water and turn it on. The water will heat up and the massage rollers will go into action to provide a soothing massage that will help relax your feet.
Overall, the Manual Massage Foldable Foot Spa Massager is an excellent choice for anyone looking to relieve foot pain and tension in the comfort of their own home.