Scale sheep farm buildings and major facilities
1. Choosing sites for sheep breeding and selecting sheep farms need to be planned according to the number of existing goats and their scale of development, funding status, and mechanization level. At the same time, local conditions should also be fully considered and production costs should be reduced. The sheep house should be built in a place with high ground, well-drained, dry and ventilated, light-transmitting to the sun and ample water. 2. The building sheep-raising sheep house is generally 4 to 6 meters wide and 2 to 3 meters high. The length is determined according to the number of sheep, and the sheep house area is calculated as 1.2 to 1.5 square meters per sheep, and a playground is built next to the sheep. , planting shade trees around. The floor is nailed into a bed with a spacing of 1 to 1.5 centimeters with wooden strips, bamboo strips or fine wooden sticks so that the feces and urine fall on the ground. The sheep bed can be divided into columns and can also be made into movable boards. 3. House requirements and design houses are divided into rams, ewes, lambs, fattening sheep pens by movable wooden fences, and grass racks, feeding troughs and drinking water equipment are provided in the circle. She set up a straw frame against the wall with a wooden strip. The height of the straw frame was about 1 meter, and a gap of 15 centimeters wide was taken. The trough can be made of cement or wood to form a long trough, generally 25 centimeters wide, 22 centimeters wide and 10 to 15 centimeters deep. The bottom of the trough is arc-shaped. It is best to leave an outlet hole outward. The drinking water equipment is installed along the wall, and an automatic water drinker can be used. It is installed every 3 meters, and a sink or basin can also be installed. 4. Medicine baths should be built near the pens to build medicine baths. The medicine baths should be formed into narrow and long pools with a depth of not less than 1 meter. The bottom of the pool should be 30 to 60 centimeters wide and the upper mouth should be 60 to 80 centimeters wide. The inlet end should be sloped to facilitate sheep. Only enter the pool; there is a certain degree of slope steps at the outlet end so that the liquid from the sheep flows back into the pool. Pain Relief Patch(Pain Areas)
Pain Relief Patch
Pain Relief Patch(Pain Areas),Shouler Pain Relief Patch,Joints Pain Relief Patch, Muscle Pain Relief Patch Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.sdxjmedical.com
[Name] Medical Cold Patch
[Package Dimension] 6cm×8cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application]
For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give fast acting pain relief for strains, sprains, cramp, bruises, swollen areas or joint stiffness.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.