Checking work and precautions for the swinging machine

2, Zui important step is to see if the screws of each component are tightened.

3, in one is to see if the power supply motor and other accessories can work properly.

4. When the three points mentioned above are completed, the operation can be started.

The contents of the swing screen shutdown need to be checked as follows:

1. Strictly follow the instructions for use to end the workflow. Zui does not change the end of the job.

2. Carefully clean the debris in the cabin to avoid hidden dangers caused by debris.

3. Keep the operation mode of the sieve machine at rest.

4, the surrounding environment of the sieve machine should be neat and tidy, try not to be contaminated with dust.

5. Do not put anything that is irrelevant around the screen.

Swing sieve notes:

In addition to homework, you should always check the specific conditions of the grain. If the grain has a knot or the color is deviated, it is necessary to remove the particles and solve the subsequent grain changes.

When using a rocking screen, it not only requires its ability, but also wants to discharge the effective particles into the work. Therefore, there are two capacity requirements for the sieve surface: the first is its ability to handle the grain, that is, it can filter the particles too much, the other is its efficiency, and the quality of the work refers to This one.

In the operation, theoretically, the particles smaller than the sieve holes of the sieve surface should pass through the sieve holes completely, but this is not the case in actual operation, which is determined according to the vibration force and the grain characteristics. Therefore, more or less, some of them cannot pass through the mesh to become their products, and become waste materials. Therefore, in the operation, they want to improve efficiency and save resources.

The swaying screen is a screening device that stratifies materials at high speed. Some common faults occur during use, such as clogging of the screen surface and insufficient amplitude when swaying. Fuyang summarized some common faults of swinging screens and analyzed them.

The power of the swinging screen cannot be started or the swinging amplitude is too small. Zui first needs to see if the motor is normal, or it may be the damage of the motor circuit. Then it is necessary to consider whether the voltage is too small. If these three points are normal, then it depends. Seeing too much material on the screen surface leads to excessive load. After Zui, it is to check whether the accessories with links on the screen surface are damaged.

If the material movement during screening is not normal, there may be scars in the drying box. In one case, the screen box is not stabilized. If the rotation is slow in the work, the bearing is too hot. This does not need to check anything, just the usual maintenance. Did not keep up or lubricate too much.

The quality after the operation is too poor, it may be that the discharge hole is not open, or the screen tension is not enough.

For the above faults, you can use routine maintenance to avoid machine failure.

Before the operation, the fuel tank should be inspected. If the oil level exceeds the standard height, it will cause problems such as temperature rise and amplitude operation. The oil in the fuel tank is too little or bad, which will cause the running shaft to wear. Always check the tightening of the screws. The new machine should be tightened after half a day of work. After the screen surface is transported at a speed, the pellets can be placed for screening. After the operation, do not discharge the material in the tank. Before the machine is shut down, the materials in the tank should be cleaned. The feeding bin should be as close as possible to the feeding nozzle to avoid spilling of the material, and the height of the feeding end and the feeding bin should not be too large to avoid the impact force brought by the feeding, so as to improve the feeding efficiency under the artificial.