Insect attracting insects feeding ducks is effective

Feeding meat ducks with insecticides and attracting insects has low cost and can be sourced on the spot, making full use of waste materials to provide rich protein feeds for ducks. Therefore, the effect is very significant. Production practice shows that when 10% of insects are added to feed, the weight gain of meat ducks can be increased by more than 15%, and the egg production rate of ducks can be increased by about 25%. It is worth promoting. The following describes the specific practices of feeding meat ducks and attracting insects.

1. Artificial Broilers Feeding Meat Ducks

1. Straw feeders feed meat ducks to clean the straw into small pieces of 3-7 cm, add water and pig manure for 1-2 hours, and then bury it for 100-150 cm in length, 60-70 cm in width, and 33-depth in depth. In a 40 cm soil pit, cover with 6-8 cm thick sludge and seal the surface with thin mud. Watered daily to keep it moist, a large number of roundworms were born after 8-10 days. At this time, you can open the soil and drive the duck to feed. One such pit is generally available for 8-10 ducks for 2-3 days. After the locusts had finished eating, they were covered with sludge, and the insects and ducks were bred again until they were cautioned.

2. Straw breeding insects Feed meat ducks in a wet place where the sun is not in direct sunlight. Dig a 1 meter deep earth pit. Spread a layer of human and animal urine on the bottom, then cover with 30-35 cm thick garbage. In the water, a variety of household garbage is finally piled up until it is slightly higher than the ground. Then it is closed tightly with mud, and often washed with rice and water to keep it moist. In the middle of a month or so, the pit is opened, and many insects grow inside and can be used for feeding ducks.

3, leaves, fresh grass breeding insects fed ducks 80% of leaves or fresh grass, rice bran 20% mixed, add the appropriate amount of water cooked, pour into the cylinder or cement pool. After 5-7 days, a large number of insects can be bred and ducks can feed.

4, cow dung breeding meat ducks feed cow dries dried, chopped, mixed with a small amount of rice bran, bran, mixed with thin mud, stacked into a diameter of 100-170 cm, 1 m high round heap, with straw or Cover the weeds with water and water 2-3 times a day to keep the heap in a semi-dry state. After 15 days, a large number of locusts can be bred, opened the grass curtains, and driven ducks to feed. After the locusts had finished eating, cows were piled up again, and many insects were bred for 2-3 days and they could continue to be used for feeding ducks.

5. Chicken droppings feeding meat ducks Chicken manure dried and chopped, mixed with a small amount of rice bran, wheat bran and thin mud and mixed and piled up, covered with straw or weeds; the top of the pile was made concave, daily Watering 1-2 times, a large number of small insects can be bred in half a month. After the worms have been eaten, the hoppers can be reared for a few days and the worms can be fed to feed the ducks.

6, pine needles feeding meat duck digging a deep 70-100 cm, length and width of the open pit, into a 30-50 cm thick pine needles, pour the right amount of Taomi Shui, covered with 30 cm thick fine soil After 7 days, a large number of locusts can be bred to feed ducks. After the worms have been eaten, they can be fed with pine needles to continue breeding worms to feed meat ducks.

Second, light trapping feeding ducks

The specific practice is to set up a duck circle in the north and to set up the entrance in the south. Afterwards, fresh swine manure or cow dung should be accumulated on the east and west respectively to attract more insects. Then put a large water basin in the middle of the pile of manure; ducks with more than 100 can use a large pot with a diameter of 1 meter; ducks with less than 100 can be used straight

Endoscopic Surgical Instruments

Endoscopic Surgical Instruments,Endoscopic Clip Applier,Urology Endoscopic Instruments,Endoscopic Sinus Surgery Instruments

Qingdao DMD Medical Technology Co., LTD , https://www.conston-tech.com