Loofah melon management
1. After emasculation and flowering vines are put on the shelf, they must be continuously pruned and the appropriate number of male flowers must be removed. In general, only one main vine should be kept per loofah, and other lateral branches and buds should be removed at any time. Loofah is a male and female flower with the same node, and there are many male flowers. To reduce the consumption of nutrients, more than 70% of male buds can be removed in time, and the buds on the node should be avoided when the male buds are removed. 2, Uguai go to the bad melons of each loofah in different stages of the melon only choose to retain 1 to 2 melons, choose to leave high-quality melons of the young melon to be up and down symmetry, bar straight, stalks are not slender, at the same time in In the first few places of the small melons that he chose to stay, he left a young melon to compete for nutrients. When the selected quality of the melon is long enough to not break, remove the small melon before it. The melons must not be allowed to rest on the top of the rack. They should be put down in a timely manner. If the melons are arched, they must be straightened by hand (there can be small stones on the flower pedicle). 3. Reasonable application of fertilizing topdressing has an important effect on fruit set and full expansion of loofah. The application time, number of times and dosage of topdressing may depend on the growth of loofah and the amount of fruiting nectar. When the length of first larvae grows to more than 4cm The first application of fertilizer must be applied. Mushi pure nitrogen is about 3 kg (equivalent to about 7 kg of urea); over 10 days, Mushi N4 ~ 5 kg (equivalent to about 10 kg of urea) is used to promote the enlargement and enrichment of loofah. ; After every 15 days or so topdressing once, each time with 4 ~ 5 kg of pure nitrogen (equivalent to about 10 kg of urea) Note: The method of fertilization should be based on pouring. Rotation is applied about 50cm away from the base of the stem to prevent near roots from being fattened.
Spacer and Bushing
The Spacers are
designed to hold materials a predetermined distance away from the surface they
are mounted to, or mount two items a set distance apart. Sizes and materials
vary depending on intended use.
The Bushings are
used as spacers between pulleys and gears to prevent damage caused by vibration
and dynamic loads. The durable bushing material is corrosion resistant.
The
material of Spacer Bushing including carbon steel, Stainless Steel, Aluminum
and Brass. Dimensions are according to custom made. The zinc-plated finish
provides some corrosion resistance.
Spacer & Bushing,Spacer Bushing,Shaft Spacer, Bushing Spacer Ningbo Yokelink Machinery Co.,Limited , https://www.yokelink.com
