There are misunderstandings in fertilization and countermeasures
How to get out of the fertilizer misunderstanding and maximize the effect of fertilizer production is a major issue that is worth paying attention to in current agricultural production. Misunderstanding 1: Ammonium bicarbonate is applied superficially or with water. Ammonium bicarbonate has the characteristics of being easily decomposed and volatilized (it is called "gas-manure"). The shallow surface application not only has a low utilization rate, but also causes ammonia to easily escape from the soil when the temperature is high. Fertilizers tend to adhere to the stems and leaves of crops, resulting in different degrees of burns, especially when pouring in the early morning. If the amount of water is small, the fertilizer can easily remain on the surface of the soil, causing loss of nitrogen volatilization. Countermeasures: When ammonium bicarbonate is used as top dressing, deeper application of ditching and tightly covering the soil; if waterlogging is insufficient after fertilization, it should be watered in time to increase fertilizer efficiency. Some data indicate that the application of ammonium bicarbonate deeper than the shallow surface can increase the utilization rate by 10 to 30%, increase production by about 10%, and increase the yield by about 8% compared with the application of water. Misunderstanding 2: The surface of urea is shallow or flooded immediately after application. Urea is an amide nitrogen fertilizer. After being applied to the soil, except for a small portion that is directly absorbed and utilized by crops, most of it is converted into ammonium carbonate under the action of urease in the soil and then is used for crop absorption; the chemical nature of ammonium carbonate is very unstable and easy to distinguish. Explain the release of ammonia. The application of urea to the surface can also cause the volatilization of ammonia. If applied to the surface of calcareous soil or alkaline soil, the volatilization of ammonia is more serious. In addition, urea can not be absorbed by the soil before it is converted into ammonium carbonate. If flood irrigation is conducted immediately after fertilization, urea will be leached to a deep layer to reduce fertilizer efficiency. Countermeasures: Urea is applied on dry land. Whether it is basal fertilizer or topdressing, attention should be paid to deep application of cover soil so that the fertilizer is placed in a moist soil layer to facilitate the conversion of urea and prevent the volatilization of ammonia after conversion; Insufficient water can be adequate, and the amount of water per acre of 20 to 30 cubic meters is better. Avoid flood irrigation. Paddy fields should be applied before irrigation, and it is best to deepen them. Generally, do not rush to water after application. Re-irrigation should be carried out every 3 to 5 days (that is, after converting to ammonium carbonate). Misunderstanding three: Diammonium phosphate is applied with water. Diammonium phosphate is a phosphorus-based nitrogen and phosphorus binary compound fertilizer. If it is applied with water, the fertilizer is easily retained on the surface, causing nitrogen to evaporate. Phosphorus remains on the surface of the soil and cannot be absorbed by the roots of the crop. Countermeasures: When using diammonium phosphate as top dressing, take a deep ditch and apply a depth of about 10 cm. Apply water and water immediately after application. Misunderstanding 4: Use calcium superphosphate seed dressing. Superphosphate contains 3.5 to 5% free acid, which has a strong corrosive effect and is used for direct seed dressing. Especially after a long period of seed dressing, it is easy to corrode the seeds and affect the seedling rate. Solution: When superphosphate is used as a seed fertilizer, the fertilizer is applied under or to the side of the seed to isolate it from the seed. Myth 5: With calcium magnesium phosphate fertilizer for top dressing. Calcium magnesium phosphate fertilizer is a weak acid-soluble phosphate fertilizer, insoluble in water, fertilizer effect is slow, it is not suitable for top dressing. Countermeasures: Calcium, magnesium and phosphate fertilizers are used as base fertilizers and applied early to allow them to dissolve and transform in the soil for a longer period of time. In order to increase fertilizer efficiency, calcium magnesium phosphate fertilizers can also be mixed with organic fertilizers or co-piled and applied. Misunderstanding 6: Human excrement is mixed with plant ash for storage and application after stacking. In rural areas, many farmers are accustomed to spreading ash in pits to absorb urine or to mix human waste with ash. As the plant ash is an alkaline substance, contact with human excreta will accelerate the volatilization of ammonia and increase the loss of nitrogen. According to the test, the mixing of the plant ash with human urine (1:1.5) for 3 days can make the loss of nitrogen 27.4%. Loss of 85.6% over 3 months of storage. Countermeasures: Change the misuse of mixed human and fecal urine and plant ash, and implement sharing. Misunderstanding 7: Human fecal urine is applied directly on the vegetables. Human fecal urine often contains many kinds of pathogenic bacteria and parasite eggs. If it is not detoxified without being cooked, direct application on vegetables will cause the vegetables to be contaminated and affect human health after eating. Countermeasures: First carry out harmless treatment, such as capping, sealing and stacking, and disinfecting the drug, and then apply it on vegetables. 3D dental scanner is most commonly utilized for cosmetic and restoration purposes, such as reconstructive therapy or oral surgery. 3D imaging allows for planning and customizing services for procedures such as bone grafts, implants, and root canals. 3D scanning is also often used to create 3D images for orthodontic treatment. Handheld 3D Scanner,3D Scanner Dental,Leica 3D Scanner,Android 3D Scanner Shandong Carved Intelligent Technology Group Co.,Ltd , https://www.demetdent.com